The basic operation course of the Winding Machine the automatic winding machine looks very complex, but it is not very difficult to operate in practice. It is mainly caused by being unfamiliar with the structure of the winding machine, and the company has no professional and technical personnel training. As a result, ordinary people have no way to start their winding machine without technicians. The basic equipment of the winding machine consists of mechanical parts and electrical control system. However, with the rapid development of science and technology, modern Automatic Winding Machine will be more difficult and sophisticated than other electronic processing equipment because it integrates many technologies such as electrical control, sensing technology, pneumatic and mechanical transmission, photoelectric detection and so on, Fuying electronics has adopted rite winding machine for many years and has familiar experience in the use of winding equipment. After we introduce it here, we believe that it can be operated simply as long as it is operated according to the method. Starting position, enamelled wire specification and winding width are the three most important winding parameters of winding machine, which are commonly used in skeleton coil. 1. How to set the winding position? Where is the winding position of the skeleton coil? In fact, there is no fixed position at the starting point of starting winding on the skeleton. The position and the beginning of the coil are determined by the coil model. Generally speaking, the specific starting position and value can be measured as long as the measurement function of the equipment control system is used; Technicians can also measure the value manually, take the specific position as the reference point and use ruler to actually measure. When setting this point, pay attention to the specific winding direction of the coil. 2. For the specific setting of enamelled wire specifications, the enamelled wires used in daily use have different wire diameters. Different enamelled wire specification settings will produce different wire arrangement effects. When using enamelled wires of different materials, pay attention to correcting the specific value of wire diameter, so that the copper wire will not be deformed. 3. Setting of winding width value we can understand the value from the starting point of the winding to the end point of the winding. Generally, the length of the winding of the coil can be known by the value straight. Of course, the small deformation caused by the applied force must be considered when setting, which will have a certain impact on the production of the winding width value. Therefore, the minimum value should be taken as the winding width by using a variety of measurement methods. 4. For the wire type characteristics of different winding coils, we should also have a good understanding of the specific number of turns, folding layers and average winding speed requirements of the product. The winding speed of the thick wire model should not be too fast. If the speed is too fast, it will cause problems such as wire jumper and step loss, and quality problems. The torque force of the winding machine must be strengthened when it is used at medium and low speed. 5. When the wound coil is square, the winding speed of the wound coil cannot be too fast, otherwise it will produce concave convex unevenness, affecting the number of folding layers and turns. Moreover, the distance between the coil and the cable arranger shall be reasonably arranged. If it is low, it is easy to fall into other layers, and if it is high, it is easy to jumper. At the same time, it is not allowed to drink the cable arranger too far, otherwise it will affect the accuracy. 6. The winding machine will reserve the functions of preset number of turns, automatic stop, positive and negative winding, automatic cross slot and so on. In the process of use, if you want to protect the winding machine, you must start and stop the idle according to steps to reduce the tension on the structure of the winding machine and the enamelled wire. Generally, it should be set within three turns. This article is from Fuying electronics and is not allowed to be reproduced without consent.
SUZHOU DEGU MACHINERY CO.,LTD